Posted on: 2016-07-26 21:52:45
<< Older post

Heating breakdown repairs



When your heating system stops producing hot water, you have to do the repairs or replace your heating system. Before you try any heating repairs Waterloo, you should check the circuit breaker to see if it is on or off or if its fuses are installed in a secure manner and are not blown. You can reset the circuit breaker to be on and replace the blown fuses and then wait 30 to 60 minutes for the water to get warm. When the water continues to be cool, you should consider other options. You should shut off the power before doing any repairs so that you avoid the risk of shock or electrocution, which can lead to burns or sometimes death. You have to shut down all the powers in the circuit when you shut down all the fuses and remove the handle on the circuit breaker or on the switch that has been dedicated to the water heater. You should remove the pocket fuse completely or you can lock or secure the panel and replace the note on a cover alert, and the work should start at the water heater. This is to prevent energising the circuit accidently while you are working. Remove the upper panel to access inside. A metal cover is normally held at place using screws. You can remove the screws and save them for the reinstallation when the repair is done. You may use the test light and the voltmeter to see if there are wiring terminals and the grounded metal case at the tank to make sure that the power is already off. When the power is on, you should not proceed until you are able to locate the circuit breaker or remove the fuse so that you may make sure that no one turns on the circuit when you are doing heating repairs Waterloo.

<< Older post

 Recent posts



 Archives